SoliForum - 3D Printing Community — Davinci 1.0 parting out. has upgraded pico b3 head

Re: Davinci 1.0 parting out. has upgraded pico b3 head

null@example.com (tommy2toes) — Tue, 22 Mar 2016 19:09:21 +0000

i need the front stepper motor is the one says 17pm-k142bp03cn. but not the rear of this as it is to long. they are different sizes even though they have the same numbers. so if you have this it measures 38mm length by 42 width 42 depth. if you do have it i will take it tell me how much you want and your paypal. thanks

Re: Davinci 1.0 parting out. has upgraded pico b3 head

null@example.com (RC1) — Fri, 15 Jan 2016 14:56:42 +0000

Hi there, don't suppose you still have the motherboard do you ?

Thanks

Re: Davinci 1.0 parting out. has upgraded pico b3 head

null@example.com (techgeek) — Tue, 05 Jan 2016 19:40:27 +0000

Looking for the led bar (that lights up the inside)....

Re: Davinci 1.0 parting out. has upgraded pico b3 head

null@example.com (wordoftheday) — Mon, 24 Aug 2015 11:56:32 +0000

I'm looking for a Z axis sensor.

Re: Davinci 1.0 parting out. has upgraded pico b3 head

null@example.com (jsntully) — Tue, 14 Jul 2015 18:03:23 +0000

Do you have an x axis connector? I have a 2.0 and am not sure if it's the same piece. I've attached a pic of what I need.

Re: Davinci 1.0 parting out. has upgraded pico b3 head

null@example.com (efes) — Tue, 07 Jul 2015 19:57:51 +0000

hello, you have shaft Y davinci 1.0 ?
2x
thx

Davinci 1.0 parting out. has upgraded pico b3 head

null@example.com (hansen644) — Tue, 23 Jun 2015 02:25:38 +0000

Parting out my davinci 1.0 has upgraded pico B3 head. my main PC board went bad. Rather just make a new printer from scratch. PM me if you want any parts thanks