Topic: Help with temperature...
Hello,
Done with PID, is this a thermistor issue?
PID Settings
P: 13.40
I: 2.62
D: 17.13
Slicer > Print the temp wont go up, I still have to manually enable it to reach 190
- wardjr
- Moderator
- Offline
Re: Help with temperature...
There can be several place that temp needs to be set.
First is the set profile temp in Slic3r
Second you can have a temp line in the custom start g-code section of your Slic3r profile.
Thirdly your host if RH has a custom start code that may have a temp line.
And of course you have the manual slider in RH that controls temp.
If any one of the first three are set incorrectly it won't get up to temp, causing your described symptoms.
Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions
- wardjr
- Moderator
- Offline
Re: Help with temperature...
Just looked at your temp chart, could you enable the output graph and post that as well. This looks like a bad connection. Turn on the heat manually and chart it from room temp all the way up and a couple minutes more. Do this without the extruder moving.
Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions