1 Topic by zburhop

  • zburhop
  • Member
  • Offline
  • Registered: 2014-03-17
  • Posts: 101

Topic: Solidoodle boot loader programmer help

It appears my Solidoodle 2 was shipped with out a boit loader so I can't update Marlin for e3d. So I baught one of these https://www.amazon.com/gp/aw/d/B00VGDYP … programmer

I plug it in to my Windows machine and it tells me the hardware is working incorrectly . I installed adafruit driver ran in compatibility mode etc with no luck. I have it plugged into the Solidoodle board and then use to the programmer and not the Solidoodle. I tried it on my Mac which doesn't recognize it at all.  Anyone have any ideas? I'm trying to ref lash the board with the updated temp limits for the e3d nozzle.


Thanks

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Solidoodle boot loader programmer help

make sure the pin layout matches and that MISO and MOSI are going to the opposite of each other.  MOSI on programmer to MISO on Board.  Past that you may be dealing with driver issues.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website