1 Topic by georgehine

  • georgehine
  • Member
  • Offline
  • Registered: 2014-11-29
  • Posts: 109

Topic: help identifying marks on print

any idea what would cause these marks? http://soliforum.com/i/?Ieftxta.jpg

Da Vinci 1.0 stock firmware and stock xyzware.
3D printer Noob.
Stock ABS filaments

2 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: help identifying marks on print

Check your bed and make sure it has no Z wobble. The glass is usually loose and can slide sisde to side during prints. Shim it with paper between the glass edges and bed frame.

Check that the bearing mounts on the vertical smooth rods are not loos. Normally the glue they used for the bearing comes loose and allows the bearing to move around independent of the bed. Clean it best you can to remove oil and grease from the surface of the bearing and the surround supports and then glue with something like goop or other strong adhesive. Or like others did just shove an exacto blade between the bearing and the mount and then break the blade off.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.