<![CDATA[SoliForum - 3D Printing Community — help identifying marks on print]]> https://www.soliforum.com/topic/12455/help-identifying-marks-on-print/ Fri, 02 Oct 2015 21:24:00 +0000 PunBB <![CDATA[Re: help identifying marks on print]]> https://www.soliforum.com/post/106853/#p106853 Check your bed and make sure it has no Z wobble. The glass is usually loose and can slide sisde to side during prints. Shim it with paper between the glass edges and bed frame.

Check that the bearing mounts on the vertical smooth rods are not loos. Normally the glue they used for the bearing comes loose and allows the bearing to move around independent of the bed. Clean it best you can to remove oil and grease from the surface of the bearing and the surround supports and then glue with something like goop or other strong adhesive. Or like others did just shove an exacto blade between the bearing and the mount and then break the blade off.

]]> Fri, 02 Oct 2015 21:24:00 +0000 https://www.soliforum.com/post/106853/#p106853 <![CDATA[help identifying marks on print]]> https://www.soliforum.com/post/106852/#p106852 any idea what would cause these marks? http://soliforum.com/i/?Ieftxta.jpg

]]> Fri, 02 Oct 2015 21:15:57 +0000 https://www.soliforum.com/post/106852/#p106852