1 Topic by chinman

  • chinman
  • Newbie
  • Offline
  • Registered: 2015-07-29
  • Posts: 2

Topic: Can't flash Repetier

When I try to load repetier firmware I get the messager "error FW version"; and I can't seem to figure out why. I have a 1.0; firmware is 1.2.7

Any help is appreciated.

2 Reply by Muledog17

  • Muledog17
  • Member
  • Offline
  • From: NJ USA
  • Registered: 2014-12-31
  • Posts: 69

Re: Can't flash Repetier

What version of repetier?

3 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Can't flash Repetier

Are you changing the name of the bin file to the same name as a valid firmware update?

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

4 Reply by chinman

  • chinman
  • Newbie
  • Offline
  • Registered: 2015-07-29
  • Posts: 2

Re: Can't flash Repetier

I was following instructions I found on a youtube video...the name of the file is

repetier-0.91-alpha-davinci10.bin

5 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Can't flash Repetier

chinman wrote:

I was following instructions I found on a youtube video...the name of the file is

repetier-0.91-alpha-davinci10.bin


I believe you are trying to flash through XYZsoftware however. If that is the case then you must rename the bin file to a valid XYZ firmware upgrade.

Follow this procedure, videos tend to leave steps out..


http://voltivo.com/forum/davinci-firmwa … issues#442

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.