<![CDATA[SoliForum - 3D Printing Community — Can't flash Repetier]]> https://www.soliforum.com/topic/11902/cant-flash-repetier/ Wed, 29 Jul 2015 17:16:36 +0000 PunBB <![CDATA[Re: Can't flash Repetier]]> https://www.soliforum.com/post/102359/#p102359 chinman wrote:

I was following instructions I found on a youtube video...the name of the file is

repetier-0.91-alpha-davinci10.bin


I believe you are trying to flash through XYZsoftware however. If that is the case then you must rename the bin file to a valid XYZ firmware upgrade.

Follow this procedure, videos tend to leave steps out..


http://voltivo.com/forum/davinci-firmwa … issues#442

]]> Wed, 29 Jul 2015 17:16:36 +0000 https://www.soliforum.com/post/102359/#p102359 <![CDATA[Re: Can't flash Repetier]]> https://www.soliforum.com/post/102357/#p102357 I was following instructions I found on a youtube video...the name of the file is

repetier-0.91-alpha-davinci10.bin

]]> Wed, 29 Jul 2015 17:12:04 +0000 https://www.soliforum.com/post/102357/#p102357 <![CDATA[Re: Can't flash Repetier]]> https://www.soliforum.com/post/102355/#p102355 Are you changing the name of the bin file to the same name as a valid firmware update?

]]> Wed, 29 Jul 2015 16:14:45 +0000 https://www.soliforum.com/post/102355/#p102355 <![CDATA[Re: Can't flash Repetier]]> https://www.soliforum.com/post/102354/#p102354 What version of repetier?

]]> Wed, 29 Jul 2015 15:18:09 +0000 https://www.soliforum.com/post/102354/#p102354 <![CDATA[Can't flash Repetier]]> https://www.soliforum.com/post/102347/#p102347 When I try to load repetier firmware I get the messager "error FW version"; and I can't seem to figure out why. I have a 1.0; firmware is 1.2.7

Any help is appreciated.

]]> Wed, 29 Jul 2015 12:20:20 +0000 https://www.soliforum.com/post/102347/#p102347