1 Topic by ne14pez

  • ne14pez
  • Member
  • Offline
  • Registered: 2013-08-13
  • Posts: 94

Topic: Looking for SD3 Motherboard

My motherboard is acting crazy.  I am looking for a replacement Rev. E board.

2 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Looking for SD3 Motherboard

Check Ebay..

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

3 Reply by AZERATE

  • AZERATE
  • AZERATE
  • PRINTiT
  • Offline
  • From: Chicago
  • Registered: 2013-11-28
  • Posts: 2,077

Re: Looking for SD3 Motherboard

You would be happier with another board. RUMBA, Sanguinololou, Azteeg, RAMPS....
If for nothing else, check into these for being able to swap/replace/upgrade the stepper drivers. The Printrboard does not allow this. If you blow a driver, you are in the doghouse.

Bare in mind these boards will require a firmware flash.

Printit Mason and Printit Horizon printers
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!