<![CDATA[SoliForum - 3D Printing Community — Looking for SD3 Motherboard]]> https://www.soliforum.com/topic/11801/looking-for-sd3-motherboard/ Sat, 18 Jul 2015 01:07:09 +0000 PunBB <![CDATA[Re: Looking for SD3 Motherboard]]> https://www.soliforum.com/post/101437/#p101437 You would be happier with another board. RUMBA, Sanguinololou, Azteeg, RAMPS....
If for nothing else, check into these for being able to swap/replace/upgrade the stepper drivers. The Printrboard does not allow this. If you blow a driver, you are in the doghouse.

Bare in mind these boards will require a firmware flash.

]]> Sat, 18 Jul 2015 01:07:09 +0000 https://www.soliforum.com/post/101437/#p101437 <![CDATA[Re: Looking for SD3 Motherboard]]> https://www.soliforum.com/post/101417/#p101417 Check Ebay..

]]> Fri, 17 Jul 2015 21:36:42 +0000 https://www.soliforum.com/post/101417/#p101417 <![CDATA[Looking for SD3 Motherboard]]> https://www.soliforum.com/post/101412/#p101412 My motherboard is acting crazy.  I am looking for a replacement Rev. E board.

]]> Fri, 17 Jul 2015 21:13:55 +0000 https://www.soliforum.com/post/101412/#p101412