<![CDATA[SoliForum - 3D Printing Community — Da Vinci Jr. 1.0 Pro with Cura and or Simplify3D]]> 2018-12-12T21:48:08Z PunBB https://www.soliforum.com/topic/17783/da-vinci-jr-10-pro-with-cura-and-or-simplify3d/ <![CDATA[Re: Da Vinci Jr. 1.0 Pro with Cura and or Simplify3D]]> http://www.soliforum.com/topic/16702/we … r-windows/

]]> https://www.soliforum.com/user/17164/ 2018-12-12T21:48:08Z https://www.soliforum.com/post/147890/#p147890 <![CDATA[Re: Da Vinci Jr. 1.0 Pro with Cura and or Simplify3D]]> You can't use octoprint with XYZ printers because they communicate using a different protocol than octoprint supports.  You can pick up a wifi dongle from XYZ however I have not heard if it works well or not.

I have used Cura on my miniMaker and the defaults seem to work well, that is pick a new generic printer with your printers dimensions.  The only changes I made were to add the nozzle wipe back in at startup, and to set the fillament back to 1.7 mm rather than the default of 3.0mm.  On top of that I found that I had to raise my z-offset up to get the first layer height correct.

http://www.soliforum.com/topic/17028/pr … minimaker/

]]> https://www.soliforum.com/user/17634/ 2018-12-12T16:13:33Z https://www.soliforum.com/post/147885/#p147885 <![CDATA[Re: Da Vinci Jr. 1.0 Pro with Cura and or Simplify3D]]> mishu_28nmv wrote:

I have the Da Vinci Jr. 1.0 Pro printer and I'm totally satisfied with it. I am trying now to print using Cura or Simplify3D (cracked) slicers, but I have no profiles for this machine. Can someone share his profile and settings? And also I have a Rpi 3B+ with Octoprint on it, but it can not detect the printer. Software: XYZware Pro and 1.0.9 firmware. What baudrate should I use? Or what should I do?


The Octprint will not work on the Da Vinci as it does not use a standard USB protocol.

As for the profile you would be better off setting everything based on your machine.

Another profile will get you in the ballpark but each machine is unique and it might be better to start of fresh then trying to tweak another profile to work for you.

]]> https://www.soliforum.com/user/7731/ 2018-12-12T16:11:23Z https://www.soliforum.com/post/147884/#p147884 <![CDATA[Da Vinci Jr. 1.0 Pro with Cura and or Simplify3D]]> I have the Da Vinci Jr. 1.0 Pro printer and I'm totally satisfied with it. I am trying now to print using Cura or Simplify3D (cracked) slicers, but I have no profiles for this machine. Can someone share his profile and settings? And also I have a Rpi 3B+ with Octoprint on it, but it can not detect the printer. Software: XYZware Pro and 1.0.9 firmware. What baudrate should I use? Or what should I do?

]]> https://www.soliforum.com/user/20466/ 2018-12-12T15:58:13Z https://www.soliforum.com/post/147881/#p147881