Topic: Silver Filament Issues
Got some new silver filament in the mail today, but it is printing nowhere near the same quality level as the white abs that shipped with the SD.
First attempt, the perimeter is really blobby, was printed at 200 deg
Dropped the temp by 10 down to 190, for the gear on the right:
It is somewhat better, but still quite rough. Is this just caused by printing too hot, or is the filament extrusion rate too fast as well? What would be really great is a guide (perhaps there is one and I don't know where it is). That has some pictures of common issues and what causes them.
Thanks for any help