Topic: Strange Flow-Rate
I'm using Repetier Host and Slic3r
To start of with, I used the settings Ian suggested and noticed that I had to much flow going out from the extruder.
http://solidoodletips.wordpress.com/201 … tier-host/
So I thought I needed a calibration, did that as well.
http://solidoodletips.wordpress.com/201 … flow-rate/
Attached a picture of when it was dialed in
So what's the problem, right!!!??
It's the actual settings I came to have:
Filament Settings
Diameter 2.1
Exctrusion multiplyer 0.82
That's weired right??
Including my config if someone has the brains to figure out what I missed ...