Topic: Minimaker, SKR 1.3, Marlin 2.0 problems
Hello i'm strugeling with my Minimaker mod for a while now.
(https://www.youtube.com/watch?v=975joiY7qwk) <<< I made a video of the printer it's current state.
Homing is always going correct, at least in my eyes. But when i start to print the Nozzle it's off-set scratches the board or is set to high, without changing the settings.
Also, i've cleaned the nozzle several time and i'm not sure why the PLA 1.75mm isn't going through the nozzle, after heated the hotend up to 200c.
Sources:
Configuration.h
https://friendpaste.com/6YYI3FkpOPegNv3fejL5Rw
Configuration_adv.h
https://friendpaste.com/6d9neirMOqVXyEZx5aE0MD
I tried to calibrate the extruder with this video;
https://www.youtube.com/watch?v=r_L79WqHegQ