1 Topic by m83.intro

  • m83.intro
  • Newbie
  • Offline
  • Registered: 2021-05-11
  • Posts: 1

Topic: Minimaker, SKR 1.3, Marlin 2.0 problems

Hello i'm strugeling with my Minimaker mod for a while now.
(https://www.youtube.com/watch?v=975joiY7qwk) <<< I made a video of the printer it's current state.

Homing is always going correct, at least in my eyes. But when i start to print the Nozzle it's off-set scratches the board or is set to high, without changing the settings.

Also, i've cleaned the nozzle several time and i'm not sure why the PLA 1.75mm isn't going through the nozzle, after heated the hotend up to 200c.

Sources:
Configuration.h
https://friendpaste.com/6YYI3FkpOPegNv3fejL5Rw

Configuration_adv.h
https://friendpaste.com/6d9neirMOqVXyEZx5aE0MD

I tried to calibrate the extruder with this video;
https://www.youtube.com/watch?v=r_L79WqHegQ

2 Reply by mjf55

  • mjf55
  • Member
  • Offline
  • From: Raleigh, NC
  • Registered: 2017-06-01
  • Posts: 336

Re: Minimaker, SKR 1.3, Marlin 2.0 problems

I know this is a little old, and Op probably has the answers, but I just went thru this on my Jr.  You need to adjust the follow
#define X_MIN_POS
#define Y_MIN_POS
#define Z_MIN_POS
to get the hotend to go to the correct x0 y0 z0.
G28 homes the hotend to where the endstops are set, but the xyz_min_pos is the distance from home, to 0,0,0