Topic: 3D prints keep failing
I just bought ender 3 v2 and the first print I done , I wasn’t impressed with it and the 3nd one was worse but I knew it needed adjusting and calibrating as the stepper motor wasn’t sitting right , I resolved that and noticed the x axis wasn’t level on both sides so I fixed that and also e steps wasn’t correct so I done that , but since then I try to print the same one but it fails every time , once it ended up off the bed and 2nd time it was stringing and I could tell it was a failure so I stopped and third time I monitored it and about 1.5mm up I heard the nozzle was rubbing against the part I was printing so I stopped it , I’m levelling the bed the best I can and the same way I done it the first time , I don’t know what the issue is and need some help , I’m getting warped corners aswell