Topic: When printing from cura on Da Vinci jr. 1.0 pro the nozzle digs into
the bed tape (this and title says it all)
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → XYZ Printing Help/Repair/Maintenance → When printing from cura on Da Vinci jr. 1.0 pro the nozzle digs into
the bed tape (this and title says it all)
sound like z offset needs to change
sound like z offset needs to change
is there a z offset you recommend? also this does not happen using XYZware
Tin Falcon wrote:sound like z offset needs to change
is there a z offset you recommend? also this does not happen using XYZware
I recommend to check if your printer is level first and then go into the offset settings. As far as number well I would lift it up until its not digging into the printer anymore and then adjust until its barely touching the bed.
SoliForum - 3D Printing Community → XYZ Printing Help/Repair/Maintenance → When printing from cura on Da Vinci jr. 1.0 pro the nozzle digs into
Powered by PunBB, supported by Informer Technologies, Inc.