1 Topic by Jonahdb2

  • Jonahdb2
  • Newbie
  • Offline
  • Registered: 2020-12-15
  • Posts: 4

Topic: When printing from cura on Da Vinci jr. 1.0 pro the nozzle digs into

the bed tape (this and title says it all)

2 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: When printing from cura on Da Vinci jr. 1.0 pro the nozzle digs into

sound like z offset needs to change

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura

3 Reply by Jonahdb2

  • Jonahdb2
  • Newbie
  • Offline
  • Registered: 2020-12-15
  • Posts: 4

Re: When printing from cura on Da Vinci jr. 1.0 pro the nozzle digs into

Tin Falcon wrote:

sound like z offset needs to change

is there a z offset you recommend? also this does not happen using XYZware

4 Reply by itsmejosephikrakowski

  • itsmejosephikrakowski
  • Newbie
  • Offline
  • Registered: 2020-12-20
  • Posts: 6

Re: When printing from cura on Da Vinci jr. 1.0 pro the nozzle digs into

Jonahdb2 wrote:
Tin Falcon wrote:

sound like z offset needs to change

is there a z offset you recommend? also this does not happen using XYZware

I recommend to check if your printer is level first and then go into the offset settings. As far as number well I would lift it up until its not digging into the printer anymore and then adjust until its barely touching the bed.