Topic: Filastruder Turning off and On
Hi everyone,
I am using and Filastruder and Filawinder set up to make some filament. After heating and extruding some filament I noticed that the Filastruder was turning itself off and then back on and then off again.
Some things I've observed which might help troubleshoot the issue:
Checked for a clogged nozzle/ barrel (the filament flows nicely when it is on so no clog suspected)
Watched the LED's while it was turning on and off, they only light up blue so current limiting is not an effect
Temp for extruding is 215 deg C
The Filastruder and Filawinder are not plugged into the same socket so I doubt too much power is being drawn at once
The screen on the board which shows current draw reads up to ~4.5A and then cuts off