Topic: vertical hopper stl for version 2
is there a vertical hopper stl for the version 2 of the filastruder? i only found them for the version 1.
1 2020-07-02 07:59:27 (edited by tekstyle 2020-07-02 08:00:10)
2 2020-07-02 15:38:55 (edited by genesat1 2020-07-02 15:39:22)
Re: vertical hopper stl for version 2
I use this one: https://www.thingiverse.com/thing:1195942
You may need to rotate the barrel 90 degrees to get the hole to line up since the hopper goes off to the side on v2 with this design.
Re: vertical hopper stl for version 2
Oh ok. That will work! Didn’t think to rotate it 90 degrees to the side. Do I need to disassemble the whole thing or can I just rotate the barrel from the flange at where to 2 joins?
Re: vertical hopper stl for version 2
tekstyle wrote:
Oh ok. That will work! Didn’t think to rotate it 90 degrees to the side. Do I need to disassemble the whole thing or can I just rotate the barrel from the flange at where to 2 joins?
You would need to rotate it into a tighter position which might be quite difficult depending on just how tightened it already is. It would probably be easier to just go ahead and take the 4 bolts off, rotate, and reassemble.
Re: vertical hopper stl for version 2
looks like i had to disassemble. now to mount the hopper after i pick up some screws. thank you