Topic: vertical hopper stl for version 2
is there a vertical hopper stl for the version 2 of the filastruder? i only found them for the version 1.
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → Filastruder → vertical hopper stl for version 2
is there a vertical hopper stl for the version 2 of the filastruder? i only found them for the version 1.
I use this one: https://www.thingiverse.com/thing:1195942
You may need to rotate the barrel 90 degrees to get the hole to line up since the hopper goes off to the side on v2 with this design.
Oh ok. That will work! Didn’t think to rotate it 90 degrees to the side. Do I need to disassemble the whole thing or can I just rotate the barrel from the flange at where to 2 joins?
Oh ok. That will work! Didn’t think to rotate it 90 degrees to the side. Do I need to disassemble the whole thing or can I just rotate the barrel from the flange at where to 2 joins?
You would need to rotate it into a tighter position which might be quite difficult depending on just how tightened it already is. It would probably be easier to just go ahead and take the 4 bolts off, rotate, and reassemble.
looks like i had to disassemble. now to mount the hopper after i pick up some screws. thank you
SoliForum - 3D Printing Community → Filastruder → vertical hopper stl for version 2
Powered by PunBB, supported by Informer Technologies, Inc.