Topic: Replacing the Power Supply Pt. 2
So I’m replacing the power supply and it turns on. However it won’t heat up. What do I do about that ?
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → Help/Repair/Maintenance → Replacing the Power Supply Pt. 2
So I’m replacing the power supply and it turns on. However it won’t heat up. What do I do about that ?
it appears something else is wrong ! Ohm out the heaters make sure there are no shorts or opens. then check voltage at the board terminals. it is quite possible something shorted and took the board or fuse aka o ohm resistors with it.
SoliForum - 3D Printing Community → Help/Repair/Maintenance → Replacing the Power Supply Pt. 2
Powered by PunBB, supported by Informer Technologies, Inc.