1 Topic by juliaragno

  • juliaragno
  • Newbie
  • Offline
  • Registered: 2020-04-06
  • Posts: 8

Topic: Replacing the Power Supply Pt. 2

So I’m replacing the power supply and it turns on. However it won’t heat up. What do I do about that ?

2 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: Replacing the Power Supply Pt. 2

it appears something else is wrong ! Ohm out the heaters make sure there are no shorts or opens. then check voltage at the board terminals. it is quite possible something shorted and took the board or fuse aka o ohm resistors with it.

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura