1 Topic by Zippy The Roach

  • Zippy The Roach
  • Zippy The Roach
  • Newbie
  • Offline
  • Registered: 2020-03-31
  • Posts: 2

Topic: Trying to follow old instructions for da Vinci 2.0 Repetier install.

Hi all,

I just picked up a da Vinci 2.0A from a school that was getting rid of it(there are only 20 hours on the service clock, so they must have gotten sick of XYZware too). I'm attempting to follow the Repetier install instructions as recommend in this old post. Unfortunately, the instructions on GitHub link out to a third party site named Voltivo Forums for the list of supported boards and Voltivo no longer exists.

Does anyone still know the list of supported boards? What I've got: da Vinci 2.0A with blue cabinet, engine board F3 running firmware 2.1.2

The jumper 37 solder pads are present, so it is erasable. I'd hate to brick this thing if it's not one of the compatible boards though.

Thanks!

2 Reply by Zippy The Roach

  • Zippy The Roach
  • Zippy The Roach
  • Newbie
  • Offline
  • Registered: 2020-03-31
  • Posts: 2

Re: Trying to follow old instructions for da Vinci 2.0 Repetier install.

There where old posts about serial numbers 3F10A and higher not working and since this one is 3F20A I had a suspicion that it wouldn't work. Prints with XYZware where garbage, so I gave it a shot anyhow. The Github instructions worked and Repetier 0.92.10 if fine on a high serial number 2.0A.