1 Topic by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Topic: E3D V6 on a CTC Dual

I am looking to convert my CTC from the MK10 extruders and hot ends it has to E3D V6 with Bowden. Those who may not know the CTC is a 24V system and uses thermocouples instead of thermistors.

So I see there are 24 volt version of the E3D and if I order two of them can I get them with thermocouples instead of thermistors? I can chnage the inputs on the Azteeg X5 I have controlling it but it means changing pin mapping in the firmware and that is just a pain and I am not sure what the original pins for thermistors where so additional research would need to be done. Aside from the carriage and some tweaking I was just hoping for a near drop in.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,623

Re: E3D V6 on a CTC Dual

Tell us what you need and we will be able to get you the correct combination.
https://support.printitindustries.com/

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website