deformation test (Page 2 of 3)

This is as seen in program after scan,
and scanned with both laser and with default setting.
Would offcause be much better with High Quality, but for this thread
i just did a quickie.

As you can see, the small white box below the model, also get the imploding look,
so size doesn't matter, as i thought.

This is after a calibration:

Just became father for these two babies
They cost 35,- Danish kroner each, its like 5.28 $.

Not that it will help my problem, but hopefully
it will be solved with time.

I hope someone will come with a solution to my above problem

Here you are.
The distance from each laser to camera is ok.

Oh and here the camera name detected:

The camera Y position looks strange.  That is the height of the center of the camera lens, as measured from the top of the turntable.   For most of us that built the original scanner, with the printed parts, that value is about 3.25" to 3.5", not 4.95".  That value also determines the height of the lasers, since they are supposed to be inline with each other.

Can you verify the height of your camera and lasers?

Here is a link to my settings.  They are from an older version of FreeLSS (1.14), but they worked great for me.  You might want to compare and see if it helps with your issue:

http://www.soliforum.com/post/113049/#p113049

4.95" is definitely not the correct Y value.  You can click the Restore Defaults button to bring the settings to their default values if you are not sure what you changed.  After any Settings change, don't forget to setup the calibration item and click Calibrate Lasers again.

- Uriah

Here is a link to the exact post knowack is referring to.

http://www.soliforum.com/post/133437/#p133437

Sorry for the delay, but it got late here last night.
Different timezone : gmt+2.

I measured it all, and it was camera Y there was wrong, all the other
settings is good.
And its calibrated again.

And as you can see, the square isn't "square"

Here is last scan:

Is this an acrylic frame?

If so, stop measuring.  Set the parameters to the numbers indicated in previous posts.

The problem may be your light source. If you are scanning with your lighting set up the same as in your preview then the scanner is seeing that shadow at the base of the bottle as a curve you need equal lighting from both sides or straight from the cameras view. Shadows will cause all kinds of issues with scanning.

There also seems to be a light source above and behind the scanning area as well. Looks to me like the focus on your camera is too far back and it sees too much of the area around the object.

From what I found with my scanner the focus of the camera should only see from edge to edge of the turn table. That also limits height to the same width as the turn table.

New update...
I dismantled my Atlas 3D completely, and when i assembled it again, i was wondering where left/right laser had to be.
Was it left as seen from turntable or from camera....
First time i thought it had to be seen from turntable...
Now i know its seen from camera... Oh well.... Shame on me. (To my defense, English isn't my mother language)
Here is two screenshot from last scan. I just can't get my arms down
I know there is still alot of work to do, like remove noise, change settings etc. BUT IT WORKS perfect !!!!!
Btw. Those new babies i just bought, they wasn't that much improvement imo. The default pair, worked just as good.
Well here is screenshot, and there is no hill below

Reversed lasers....  Know we all know when we see that kind of deformation.

Nice job with the scans.