Topic: makerbot 2 large part heat failure
I have an interesting problem. My makerbot was running awesome. Then i tried a part that took up most of the bed and it got a "loss temp"failure. So then i printed like 30 smaller parts no issue. Then again tried a big mart and got two failures at the exact same place in the exact same part. Then printed a smaller part and no issue. I replaced the thermocouple recently so i know for sure its fine. Its not a time issue because i can easily print parts with a smaller bed surface area that las well over 5 hours. Also i noticed on the big parts if i pause the print the temperature started to climb back up where it should be. Anyone seen this before?
Zach