Still can't print anything over 195x195mm
• Below 3 items tell me the basic HW/FW/belts/limit switches are fine
o Smaller prints are fine
o Probing/levelling is fine
o Homing the head, or counting out a full 200x200mm in manual 1 or 5mm steps is also fine
• But...large prints:
o Bang the head into the back and left wall on the first layer
o 2nd layer clear is then clearly shifted right and forward – is this belt skip or FW? Don’t know.
o Print placement looks fine in Soliprint window – but it prints shifted
o Also because the print is shifted left, it often drops the probe – printer has to be emergency stopped manually to avoid severe damage.
At a guess I would say deep in the slicer or FW there is a small bit of code that doesn’t quite understand what happens on large prints.
Has anybody actually printed anything over 195x195mm? (my project is square, so printing Diagon Alley doesn't work )