Topic: FreeLSS 1.7 Auto-Calibration problems
I've just updated my setup to v1.7, and for the past hour, I've been trying to use the auto-calibration without any luck.
First of all, just prior to updating, I ran a fresh calibration using the original Atlas calibration tool, and my home made checkerboard pattern. Then I updated to v.1.7, and went back to the camera to run the new calibration.
The first thing I noticed, is that the cross-hairs were now way off to the left, when just prior to the calibration were perfectly centered on the turntable.
I took a test shot, and that showed the blue line lined up with the lasers. I thought that was weird, so I did it again, with the same results. the test shot appears lined up with the blue line, even though the camera doesn't see it like that.
So I re-centered the camera, and did a test. Even though the camera is centered, the test is now way off.
Last but not least, when I click on "Calibrate", I get "Could not positively detect which pixels corresponded to the XY plane"
I tried different lighting, different laser threshold, I tried the Atlas Calibration tool, and I tried my own checker-board pattern tool, every time I try to calibrate I get this error.
SD3 printer w/too many mods, Printrbot Simple Maker Ed., FormLabs Form 1+
AnyCubic Photon, Shining 3D EinScan-S & Atlas 3D scanners...
...and too much time on my hands.