Can someone point me at a newbie DaVinci orientated Repetier faq? I did a search/read the forum and there are alot of bit's and pieces on it on this forum of interest. The website isn't much better.
Specifically, I'm wondering if out of the box Repetier can do as good as the DaVinci stock firmware for me just plugging in a STL file and printing. I.E. not alot of tweaking for the same out of the box quality. I use my 3D printer as a tool and I've got something I need to get done. DaVinci 1.2.4 currently has my printer bricked. I'll have time later for tweaking and repetier sounds like the way to go.... obviously I need to do something with the firmware load, but if I'm going to reset the adrino board and force feed some firmware to it I'd rather be going forward then back.
Also, Da Vince just told me the real reason they don't allow downgrades. ;-) See below.
Thanks again for the help here... it was excellent.
-Jeff
--------------- (after they admitted they had an issue, their response to if I could reload 1.2.3 )-----------
Dear Mr. King,
We're sorry for the inconvenience caused.
Please kindly note that in order to preserve the lifetime and good print quality, the firmware cant be downgraded.
And please kindly be noted that we are checking this to the relevant department and will advise you as soon as possible.
Thank you.
Best Regards,
Customer Care (Mae)
XYZprinting Inc.