1 Topic by dloring

  • dloring
  • Newbie
  • Offline
  • Registered: 2014-12-27
  • Posts: 1

Topic: prints coming out with the layers offset

I have the da vinci 1.0 and i attempted the star demo, but the layers seem to be offset (see pic).  I had to cancel that and downloaded a simple ring demo, and it too was offset (see pic).  Anyone know what could cause this?

The only modification I had to make to the printer was to move the y-axis home switch forward about an inch so that it would home properly (err code 0031), other than that, it is stock. 

Also, calibration fails with codes +305, ERR, ERR

Any help is appreciated.

Thanks,
david.

Post's attachments

20141226_164719.jpg 3.46 mb, file has never been downloaded. 

You don't have the permssions to download the attachments of this post.

2 Reply by georgehine

  • georgehine
  • Member
  • Offline
  • Registered: 2014-11-29
  • Posts: 109

Re: prints coming out with the layers offset

you need to calibrate it before doing anything.

Da Vinci 1.0 stock firmware and stock xyzware.
3D printer Noob.
Stock ABS filaments

3 Reply by georgehine

  • georgehine
  • Member
  • Offline
  • Registered: 2014-11-29
  • Posts: 109

Re: prints coming out with the layers offset

please view this to get  your printer calibrated
http://www.soliforum.com/topic/8408/bed … beginners/

Da Vinci 1.0 stock firmware and stock xyzware.
3D printer Noob.
Stock ABS filaments