Re: E3D extruder on a new SD3 FW HELP..
I fixed my bed temp maxing at about 96 and taking a long time to reach it with a few tweaks to the firmware again.
Lines 91-94 in configuration.h, I changed the bed sensor table from 6 to 1.
#define TEMP_SENSOR_0 6 //{SD Patch}
#define TEMP_SENSOR_1 0
#define TEMP_SENSOR_2 0
#define TEMP_SENSOR_BED 1 //{SD Patch}
Lines 162-165 in configuration.h, I uncommented pidtempbed which gives me perfectly flat 115C with the values already in the firmware.
// If this is enabled, find your own PID constants below.
#define PIDTEMPBED
//
//#define BED_LIMIT_SWITCHING
For the ones bothered by the firmware not displaying correctly in RH:
Lines 32-34 in language.h, I have the printrboard and using 81 myself. The firmware I have from lawsy's github doesn't have that as an option in the language tab. I just added the extra "|| MOTHERBOARD == 81"
#elif MOTHERBOARD == 62 || MOTHERBOARD == 33 || MOTHERBOARD == 34 || MOTHERBOARD == 81 //{SD Patch}
#define MACHINE_NAME "Solidoodle" //{SD Patch}
#define FIRMWARE_URL "http://github.com/mlaws/solidoodle2-marlin/" //{SD Patch}
I fired up both the bed and the extruder after the bed stablilized temp. Neither fluctuated and maintained a flat tempurature, which rules out the power supply lacking like I was previously suspecting.
I hope this can help some of you guys. Happy Printing!