1 Topic by neil.thorpe

  • neil.thorpe
  • Member
  • Offline
  • Registered: 2013-09-22
  • Posts: 16

Topic: Guide bars printable

Hi, ive just about completed everything and was wondering if anyone has the 3d files for the guide bars and the bits to hold on the holes of the fan so I can print and add to my filastruder enclosure.

Thanks

Neil

2 Reply by OSPrinting

  • OSPrinting
  • Member
  • Offline
  • Registered: 2013-01-12
  • Posts: 81

Re: Guide bars printable

I'm not sure which type of enclosure you are using but I know the parts for the one we designed can be found on thingiverse.
http://www.thingiverse.com/thing:105877

Hope that helps.

3 Reply by neil.thorpe

  • neil.thorpe
  • Member
  • Offline
  • Registered: 2013-09-22
  • Posts: 16

Re: Guide bars printable

Cheers thats the one im after

4 Reply by neil.thorpe

  • neil.thorpe
  • Member
  • Offline
  • Registered: 2013-09-22
  • Posts: 16

Re: Guide bars printable

Would you have the guide bars somewhere else, the actual bars appear to be a circle thats only 1 layer in height when put through either skienforge or pronterface. the base V2 works fine.

5 Reply by OSPrinting

  • OSPrinting
  • Member
  • Offline
  • Registered: 2013-01-12
  • Posts: 81

Re: Guide bars printable

This should work.
https://www.dropbox.com/s/s35tn9lee0wvr … %20Bar.stl

6 Reply by neil.thorpe

  • neil.thorpe
  • Member
  • Offline
  • Registered: 2013-09-22
  • Posts: 16

Re: Guide bars printable

Thanks, this had the same issue, so opened in tinkercad and found the reason, its very very small, so ive increased its size a good few hundred percent.

Thanks again

Neil

7 Reply by elmoret

  • elmoret
  • Filastruder
  • Offline
  • Registered: 2012-10-11
  • Posts: 6,048

Re: Guide bars printable

inches = 25.4 mm. You can scale by that factor if needed. STLs are unitless, the units are assumed by the slicing software.

Filastruder - the robust, inexpensive filament extruder
E3Dv6 All Metal Hotend - the premier 3D printing hotend