Re: some questions
Measure the filament at several point with a caliper and enter the average. I've never seen filament that was actually 1.75.
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → Solidoodle Discussion → some questions
Measure the filament at several point with a caliper and enter the average. I've never seen filament that was actually 1.75.
Under the dimensions tab there is filament diameter (just noticed it) which this was not in the older version? default looks like its set to 2.8 but should i be changing this to 1.75?
Absolutely.
ive been going along and my filament is between 1.74 and 1.76 at the moment
Heres another question, on my prints it seems to extrude a bit too much on the solid layers so the extruder ends up draging through the plastic, on the other layers its all fine and then when it gets to the end it does a similar thing, although this seems to mainly effect small prints
SoliForum - 3D Printing Community → Solidoodle Discussion → some questions
Powered by PunBB, supported by Informer Technologies, Inc.