it is nice to see that they are still working on new stuff, but to be perfectly honest, I do not have a need of it
I rarely have the need to change a nozzle...
in over 7 years, i think i have had all of 2-3 clogs...
I dont change nozzle sizes, so no needs there...
i dont run overly abrasive materials, so no need to change nozzles frequently there...
I also have to take issue with the non-replaceable thermistor... having to replace the entire heater setup is not cost effective to me
just not something i need.. but for those that do need them.. or just want them "because" - have at it.
SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1