Topic: Access to the port 'COM3' is denied
I updated my Repetier Host from V1.0.6 to V1.5.4 and when I tried to connect my Solidoodle 4 to the new version I received the error
"The connection failed with the following error: Access to the port 'COM3' is denied.. Make sure your printer is connected, enable and connection data is set correct. Open printer settings?"
I confirmed my printer does show up in device manager "Teensy USB Serial (COM3)"
Uninstalled and reinstalled the Solidoodle Driver.
I confirmed the bit's per second matched up (Repeiter was set to 115200 so I matched the device manager to that, but I also tried several others.)
I reverted back to Repeiter Host V1.0.6 and receive the same error.
I have rebooted 5+ times during all of this and tried several combinations of disconnecting the solidoodle and opening repetier.
any help is greatly appreciated.
Setup:
Solidoodle4
Windows 8
Repetier Host V1.0.6 and V1.5.4