You are not logged in. Please login or register.
SoliForum - 3D Printing Community → Software & Firmware → Repetier question
I sliced this mask (http://www.thingiverse.com/thing:39851) Using Slic3r .3mm in Repetier, and I'm just wondering if the resulting G-Code image is anything relevant to the print (What it will look like), or it's just what it looks like in the program.
It is close to what it will look like, the light blue lines is the path the extruder will make, you can turn that off with the show travel button at the top and then you can see pretty much what it will look like.
It is close to what it will look like, the light blue lines is the path the extruder will make, you can turn that off with the show travel button at the top and then you can see pretty much what it will look like.
Ahh, alright.
And thanks for the heads up about the travel lines, I would have continued to look over that button if you hadn't told me
Schieggster,
I printed one of these guys before. Check out my end results here:
http://www.soliforum.com/topic/987/low- … able-mask/
SoliForum - 3D Printing Community → Software & Firmware → Repetier question
Powered by PunBB, supported by Informer Technologies, Inc.
