26 Reply by hammade90

  • hammade90
  • Member
  • Offline
  • From: US-Eastcoast
  • Registered: 2014-09-27
  • Posts: 72

Re: Rumba vs Ramps? Help with rebuild...

So far all is going well. Just have a few bugs to work out...I am thinking mainly firmware issues?

"SD3" 5/02/13 03943, RAMPS 1.6+, Enclosed,  360W12V30A PSU, E3DV6(new model), Nema17 .9 (E)  Over kill Y brackets, Y drive Bearings, Y-Direct Drive, Hale bed heater on 3/16 aluminum, Lawsy Carriage upgrade, gt2 20T Pulleys.

27 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: Rumba vs Ramps? Help with rebuild...

So far all is going well. Just have a few bugs to work out...I am thinking mainly firmware issues


when configuring a new machine part of the game  my friend.

Also do not rush the wiring  do it take a break clear  your mind and inspect it do this twice if needed. Also if you have a friend  let him or her check your work.

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura

28 Reply by hammade90 (edited by hammade90 2019-01-22 04:48:21)

  • hammade90
  • Member
  • Offline
  • From: US-Eastcoast
  • Registered: 2014-09-27
  • Posts: 72

Re: Rumba vs Ramps? Help with rebuild...

Tin Falcon wrote:

So far all is going well. Just have a few bugs to work out...I am thinking mainly firmware issues


when configuring a new machine part of the game  my friend.

Also do not rush the wiring  do it take a break clear  your mind and inspect it do this twice if needed. Also if you have a friend  let him or her check your work.

I was expecting a few. I spent about 10hours wiring...sad to say,my only 3DP friends are only on here:/ at least I have all of you!<--very thankful for.

"SD3" 5/02/13 03943, RAMPS 1.6+, Enclosed,  360W12V30A PSU, E3DV6(new model), Nema17 .9 (E)  Over kill Y brackets, Y drive Bearings, Y-Direct Drive, Hale bed heater on 3/16 aluminum, Lawsy Carriage upgrade, gt2 20T Pulleys.