1 Topic by dasaint80

  • dasaint80
  • Newbie
  • Offline
  • Registered: 2016-11-10
  • Posts: 1

Topic: Bed leveling nightmares!

Hey all,  I have a davinci AiO 1.0 with repetier .92.10M it was running fine until my x axis started acting up, I fixed it (it needed to be greased up and tighen a bit).

Now I'm having a hell of a time getting a good quality print. Just leveling the bed it's become a nightmare. I'm at my witts end!

Auto leveling and z probing work fine but when I try to print the extruder cartridge bangs against the bed even after the z offset is set to -2.46mm.

I've tried using simplify3d, repetier host, or pronterface and it still has the same issue.

Thanks,

Steve

2 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Bed leveling nightmares!

dasaint80 wrote:

Hey all,  I have a davinci AiO 1.0 with repetier .92.10M it was running fine until my x axis started acting up, I fixed it (it needed to be greased up and tighen a bit).

Now I'm having a hell of a time getting a good quality print. Just leveling the bed it's become a nightmare. I'm at my witts end!

Auto leveling and z probing work fine but when I try to print the extruder cartridge bangs against the bed even after the z offset is set to -2.46mm.

I've tried using simplify3d, repetier host, or pronterface and it still has the same issue.

Thanks,

Steve

http://www.soliforum.com/topic/8408/bed … beginners/

Should be all you need.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

3 Reply by Grendel

  • Grendel
  • Grendel
  • Member
  • Offline
  • From: Canterbury, Kent, UK
  • Registered: 2017-03-03
  • Posts: 108

Re: Bed leveling nightmares!

now I may be wrong, but does the xyz not work in reverse when setting the correction? I am not certain, but I use the manual method for levelling and that works fine for me