You are not logged in. Please login or register.
SoliForum - 3D Printing Community → XYZ Printing Hacks & Mods → Replacing the Filament feeding system
hi.
my firmware is 2.2.7
And i do hack my NFC tag's if that is what u mean with ''chips'' ?
i got the password for one of the original NFC tags and i use my phone to change the length on fill thats on the spool, and that work grate 
But thanks for the reply
I did just wonder if i was the only one that got those extra cables 
Really glad you are able to hack your tags. It was my understanding that version 2.2.7 and above you would not be able to used hacked tags.
Not sure what you mean by extra cables?
i think it must be 2.2.7 
it say under system version 2.2.7
what i mean by extra cables.
i mean that if they had the sensor stuff as me, there must be some cables hanging.
But they just removed them 
anyway. i just bought this from ebay (left hand)
http://www.ebay.com/itm/231778526162?_t … EBIDX%3AIT
I hope this will help me out
That was quicker than I expected. If you look at that picture you can see the pins inserted into the connector, they are ordered from left to right blue red green black
That's coming from the motor to the factory plug. I just wrapped white electrical tape over the solder joints to protect them from crossing with another wire. If that doesn't work for some reason it doesn't take much time to figure out what order will spin the motor in the right direction.If I ever find the correct connector I'll switch those pins out for that.
HyruleJedi86,
These instructions were terrific. I got my filament stepper in and not a peep out of it since. Thank you very much for the help.
Glad it helped you. I was looking for help from someone that posted something similar but they never ended up coming back to help us. That's what made me try to figure it out and post here. Hopefully it helps more people but one thing is for sure; DaVinci needs to improve their stock feeding system.
How are your prints looking with the new motor?
The prints are about the same, but the grinding sound is now a thing of the past.
SoliForum - 3D Printing Community → XYZ Printing Hacks & Mods → Replacing the Filament feeding system
Powered by PunBB, supported by Informer Technologies, Inc.
