Re: Da Vinci to Ramps - bed thermistor question
Will do. Thanks!
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → XYZ Printing Hacks & Mods → Da Vinci to Ramps - bed thermistor question
Will do. Thanks!
Karltinsly, i'm also upgrade to Ramp1.4.
How did you determine which wires are positive and negative on stepper motors?
Karltinsly, i'm also upgrade to Ramp1.4.
How did you determine which wires are positive and negative on stepper motors?
They are are marked on the drivers and you can see the traces from the drivers leading to each pin of the connector on the mainboard. Thats how I did mine.
Thanks Carl for that tip.
Is it possible to use stock optical stops on my Da Vinci 2.0?
Not sure if I need to replace the stock Davinci 2.0 power supply or not? Will it burn out the mega2560?
Almost ready to compile and power up.
Here are a few of the mods I have done to my XYZ DaVinci 1.0, Replaced the bed so it has 4 corners I can adjust the height, I also added a four port terminal strip at the bottom in case I would like to change the heatbed or sensor easily. Next is the side filament load, loaded via a Bowden setup. Replaced the mobo with a Ramps 1.4 and added mechanical endstops On top added another terminal strip for hotend, sensor, 12v extra, fan control, all for easy replacements. Replaced x carriage to accommodate an E3D V6 and put a servo auto leveling on it as well.
continue of pictures
If you're using Marlin, can you share the configure.h file?
SoliForum - 3D Printing Community → XYZ Printing Hacks & Mods → Da Vinci to Ramps - bed thermistor question
Powered by PunBB, supported by Informer Technologies, Inc.