Topic: The Champ - Another Atlas 3D Scan
Here is another scan of a Warren Stratford figurine. I'm not sure if there's a name attached to this, but I'll call him "The Champ".
Anyway, this is another Atlas 3D scan. The figurine is just under 6" tall, and I did 3 separate hi-res scans (about 3 hours in all). The first scan was upright in the center of the turntable, followed but a tilted back scan, and a tilted forward scan, which helped pick up additional detail.
The 3 scans were then imported into MeshLab on separate layers, cleaned of any unwanted noise, then aligned. I then ran the "Compute Normals for Point Sets" filter for each Layer, then merged all 3 layers. After that I ran the Poisson Surface Reconstruction filter.
The resulting mesh seen below has had no additional retouching work, and as you can see it's pretty good as is. In the next day or so , I'll give it a little touch up in MeshMixer.
BTW, the merged PLY file contains 1.1million vertices, and is about 60MB in size. The reconstructed STL file has nearly 2 million faces and takes up more than 94MB.
SD3 printer w/too many mods, Printrbot Simple Maker Ed., FormLabs Form 1+
AnyCubic Photon, Shining 3D EinScan-S & Atlas 3D scanners...
...and too much time on my hands.