Topic: Bed bounces
So the printer after several runs of "okay" prints, is not printing successfully. After Z-calibration I'll run a print and it's "acting" like its hovering higher than the z point selected. When it lays down the brim, the layer wont adhere and it will just drag with the extruder as will the rest of the print until I stop. This happens with every print EXCEPT a companion cube (for some reason?). I noticed this all began happening after the bed started to bounce during calibration and during printing. The video shows it during calibration.
Not sure what's causing the bounce, I added the screws that came with Solidoodle's "update kit" and was able to print after installing everything and dial the trimpots.