Topic: Extrution Problems 2
Hello Gentlemen,
I have read the similar topic previously opened about extrution problem. Which my problem looks similar, however the suggestions did not help mine to get resolved!!
Extruding stops after certain time during printing, the printer does not stop, only extruding stops. The gear still runs, strapping the filament, it seems like the wire clogged in the hotend.
I have tried the same model (approximately total 3 hours printing), and the extrusion stopped at different times; 20 mins, 1 hours, etc.
The previous model did the same thing at the first try, then luckily it did finished the model at second try.
This is my third print after i bought this printer 8 moths ago. I had some problems in the beginning, then i started following the forums time to time. Now, i need the printer, and another problem.
What i have done so far regarding this problem;
-clean the nozzle, used acetone and a pin to clean the hotend
-tightened extruder gear, which works fine
-increased the heat up to 250 C (i am using the first filament came with the printer)
-pushed the filament by hand, and goes trough the hotend
-extract the filament from the sw, and it works fine
I have read about possible sensor problems (or assume the heater might cause the same thing), but i do not have proper device to measure the temp when stops.
Please let me know what you think in this case.