1 Topic by Lord_Atrix

  • Lord_Atrix
  • Newbie
  • Offline
  • Registered: 2015-08-03
  • Posts: 4

Topic: ATLAS 3D Hardware Details

I was wondering if anyone could give me details about the hardware used in the Atlas 3D. The only details I can find is from this blog post: http://www.oceanstatemakermill.org/tag/3d-scanner/

What circuit board is used to connect the lasers and stepper motor to the raspberry PI?

What kind of lasers is used?

What kind of stepper motor is used?

Any details you can give me would be great

2 Reply by pirvan

  • pirvan
  • pirvan
  • Member
  • Offline
  • From: San Francisco
  • Registered: 2013-03-27
  • Posts: 1,797

Re: ATLAS 3D Hardware Details

I think you need to start here:

http://www.soliforum.com/topic/10487/tr … intenance/
There are a lot of links you can use in the first post

Another excellent thread is this:

http://www.soliforum.com/topic/7317/pri … r-scanner/
It details the inception of the scanner, and even shows details of the circuit board, and components.

Good luck.

To print or, 3D print, that is the question...
SD3 printer w/too many mods,  Printrbot Simple Maker Ed.,  FormLabs Form 1+
AnyCubic Photon, Shining 3D EinScan-S & Atlas 3D scanners...
...and too much time on my hands.