1 Topic by Jimmy143

  • Jimmy143
  • Member
  • Offline
  • Registered: 2014-12-28
  • Posts: 22

Topic: I need help please !! i can't level my bed

Hello everyone.

I'm new on 3D printing .. and i just install my Aurora Reprap Prusa I3. but i face alot of problem to fix..

my bed leveling is so bad. and i can't print in the center  the extruder start from left or right. and i can't see where is the problm.

please i need help to solve this problem.

i need to start calibrate it to be printing in the center.

2 Reply by Jimmy143

  • Jimmy143
  • Member
  • Offline
  • Registered: 2014-12-28
  • Posts: 22

Re: I need help please !! i can't level my bed

can anyone help ?

3 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: I need help please !! i can't level my bed

I think there is a slight language barrier here.
Sounds to me like you have the dimensions of your print area defined incorrectly.
Pictures help along with screen shots, including what host and slice software will help as well.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

4 Reply by Jimmy143

  • Jimmy143
  • Member
  • Offline
  • Registered: 2014-12-28
  • Posts: 22

Re: I need help please !! i can't level my bed

wardjr wrote:

I think there is a slight language barrier here.
Sounds to me like you have the dimensions of your print area defined incorrectly.
Pictures help along with screen shots, including what host and slice software will help as well.

yes sorry I'm so bad in English sad

ill try to take picture to let you see my problem.