1 Topic by nathankau (edited by nathankau 2012-12-13 04:53:30)

  • nathankau
  • Member
  • Offline
  • Registered: 2012-11-12
  • Posts: 18

Topic: Perimeter vs Infill strength

I'm printing some walls that are 3mm or 7 threads wide. Will the wall be stronger if it had 2 perimeters and infill (38%) or 3 perimeters and a tiny bit of infill? Thanks.

2 Reply by MeshMoth

  • MeshMoth
  • Member
  • Offline
  • Registered: 2012-08-08
  • Posts: 159

Re: Perimeter vs Infill strength

I would think so.. I think its like an egg or like insects... the hard stuff on the outside protects the squooshie stuff on the inside...