1 Topic by mikenmel08

  • mikenmel08
  • Member
  • Offline
  • Registered: 2014-08-15
  • Posts: 37

Topic: Can I use Simplify 3D?

Don't want to spend the money till I'm sure I can use it...... I'm running a Davinci 1.0 that has been flashed with Repetier firmware...... Anybody know if this will work?

Thanks

2 Reply by wire10ga

  • wire10ga
  • wire10ga
  • Member
  • Offline
  • From: Arkansas
  • Registered: 2012-09-14
  • Posts: 665

Re: Can I use Simplify 3D?

Per their printer support page, it says it will take the G-code on SD card but not drive it drive it directly.
http://www.simplify3d.com/software/supported-printers/  If you changed the firmware, if you can run Repetier Host on it now, then I would guess that it should work.

SD2 - Glass Bed, Fans on PCB and Y motor, Custom enclosure
Slicer - Simplify3D

wire10ga's Website

3 Reply by mikenmel08

  • mikenmel08
  • Member
  • Offline
  • Registered: 2014-08-15
  • Posts: 37

Re: Can I use Simplify 3D?

wire10ga wrote:

If you changed the firmware, if you can run Repetier Host on it now, then I would guess that it should work.


Thats kind of what im thinking also , I just don't want to waste $140.......was hoping someone here would know for sure......