Topic: I am incapable of finishing projects.
Again.. Moving on to new things before getting anywhere near completion of my hundred other projects.
Seriously I think it's probably the most annoying thing about printers.. And being unable to concentrate on singular items.
This time a chest armour set from Halo 4, surprise surprise.
Specifically the Pathfinder Mjolnir gen2 variant.
I took the in-game ripped model and attempt to modify it's low poly mesh into something resembling the textured model in-game.
Evidently they do most of the detail with textures to save on rendering time.
This is hopefully not unlike what it'll look like once finished.
And here's a rear view of the original artists concept:
And the crap I managed...
Sliced:
And started the prints:
With 8 kilos of PLA pellet on the way I should be able to knock over the printing rather quickly.
Hopefully the OrdBot doesn't explode along the way.
Might even be able to print a helmet to go along with it.
Anyway, if you've gotten this far.. Thanks for reading my idle ramblings 
