1 Topic by aaronstalling

  • aaronstalling
  • Member
  • Offline
  • Registered: 2014-04-10
  • Posts: 43

Topic: Help with doing the Hysteresis fix

Could someone please ELI5 how to edit my SD3 firmware to add the hysteresis fix code please ?http://www.soliforum.com/topic/313/hysteresis-fix/

So far I'm trying to follow the instructions here:  http://www.soliwiki.com/Updating_Solidoodle_Firmware
How can I tell if I have a ATMega644P (Solidoodle2 default chip) or ATmega1284P

2 Reply by grob

  • grob
  • grob
  • Member
  • Offline
  • From: Sydney, Australia
  • Registered: 2014-01-02
  • Posts: 900

Re: Help with doing the Hysteresis fix

For reference, the marlin you are looking for is here, along with some instructions:
https://github.com/mlaws/solidoodle2-marlin

Do you have a printrboard (with the drivers soldered on, not on removable carriers)?
Read the number on the largest square black thing on the board, that will tell you what microcontroller you have.

SD3. Mk2b + glass, heated enclosure, GT2 belts, direct drive y shaft, linear bearings, bowden-feed E3D v5 w/ 0.9° stepper
Smoothieboard via Octoprint on RPi