26 Reply by dave

  • dave
  • Member
  • Offline
  • Registered: 2012-12-05
  • Posts: 19

Re: Part not sticking to bed

Not sure, I'm feeding overhand....

27 Reply by devilman2075

  • devilman2075
  • Member
  • Offline
  • Registered: 2012-08-21
  • Posts: 154

Re: Part not sticking to bed

dave wrote:

I have the cover but when I use it I find I break the filament occasionally at the extruder head due to the sharp angle it must bend due to the cover being so close to the head.

Might have to make something that actually works, since it does hold a fair amount of heat inside when it is on.

Try setting the case on top of the screws. It will give you a bit more room without needing anything more hardware wise